So I will load another core perhaps the 16o8i. But I am worrying that my Guzunty Pi will refuse to load again, as it did the very first time. I guess there should be some intermittantly failing solder joint somewhere, or may be a very weak trace somewhere.
Anyway, I think I better have another one on hand, so that I can easily do swap or pair troubleshooting whenever one board fails.
This time I think I will use a female header, so that I can directly plug into the RPi without any flat ribbon cable. I am also thinking of making a hybrid connector by stacking a SMD type of male connector on the soldering side of the female header.
.END
No comments:
Post a Comment